Tessmar Oyndarfjordur Armless Slipper Chair

A 26 inch wide armless slipper chair in a Blue Floral Velvet print, on 10 inch gold metal legs, with a solid wood frame and a 250 pound rating.

The listed footprint is 31 inches high, 26 inches wide, and 30 inches deep. The rounded slipper back reads larger than the seat, so measure the full arc before you place it against a wall.

• Channel-tufted floral armless slipper chair

  The back is channel tufted into vertical ribs that curve into a rounded slipper shape, with no arms on either side. A teal velvet ground carries a dense floral print of pink and orange blooms with butterflies and dragonflies worked through it, the same print running across the back and the boxed seat cushion.

• Slim gold legs, small footprint

  Four splayed, high-gloss gold metal legs lift the chair well off the floor, giving the whole piece a light, mid-century stance despite the busy print. It is sized for a corner or a reading nook rather than a main sofa spot, small enough not to dominate a room.

• Legs attach, then remove

  Assembly is just the four legs, threaded on by hand at home with the included hardware, no tools beyond what comes in the box. They are removable again later too, which makes the chair easier to carry through a narrow doorway in two lighter pieces rather than one bulky one.

• Spot clean, dry solvent only

  Clean the velvet with a dry, solvent-based cleaner rather than water, which can leave a ring or flatten the pile. Spot treat marks as soon as they happen, working from the outside of the spot inward so it does not spread across the busy print.

• Seat rated for one person

  The seat is 22 inches wide and 21 inches deep at an 18 inch seat height, with a 14.5 inch back rising above it. Foam over sinuous springs gives it a supportive sit rather than a deep sink, and it is rated to 250 pounds for one person.

• Light chair, removable legs

  At just 20.9 pounds, this is one of the lighter chairs to carry, and the legs come off again after assembly, so it can travel through a narrow doorway or a tight stairwell turn in two smaller pieces if the full chair will not clear. Overall footprint is 26 inches wide and 30 inches deep.

• Wood frame, sinuous springs

  The frame is solid and engineered wood, holding sinuous springs under the seat for long-term support. Foam on top is the fill, at a 1.5 pound density, giving the cushion enough structure to hold its shape rather than pack down flat.

• Teal floral velvet print

  Upholstery is a polyester velvet with a dense floral print across a teal ground, pink and orange blooms mixed with blue and yellow butterflies and pale dragonflies. The same fabric wraps the channel-tufted back and the seat, so the pattern lines up rather than clashing panel to panel.

• One chair, legs and hardware

  What arrives is the chair body with the four gold legs and their hardware included, ready to attach at home; there is no separate cushion cover or extra pillow in the box. It carries a 30 day limited warranty from the manufacturer.

Good to know

• Tape a 26 by 30 inch rectangle; the curved back adds height at the wall.
• Seat height is 18 inches. Check that against the tables you already own.
• At 20.9 pounds it is a one-person carry, then four legs attach at home.
• Weight capacity is 250 pounds, a single-seat rating.
• Attach the four 10 inch gold metal legs. The chair body arrives assembled except for those legs.
• Sold as one armless slipper chair. Side table, rug, curtains, plant, and other room furnishings are styling only.