Tessmar Soldarfjordur Push Back Recliner

A 34.6 inch wide manual push back recliner in brown faux leather, with rolled arms, nailhead trim, and a 330 pound rating.

The listed footprint is 39.8 inches high, 34.6 inches wide, and 36.6 inches deep upright. Reclined it needs 65 inches of depth, so leave that much room behind it before it goes in a corner.

• A Padded Back With Nailheads

  Two broad padded back cushions sit between rolled arms lined edge to edge in dark nailheads for a retro, clubby look. It reads more like a classic accent chair than a modern recliner, so it fits a living room or reading nook without looking like a mechanism on legs.

• Lean Back, No Lever

  This is a push back recliner: lean your weight into the back and it tips into a partial recline while the footrest extends, then push up to close it again. There is no lever and no motor, just your own weight doing the work, which keeps the silhouette clean on all sides.

• Ships Partly Built

  The chair arrives partially assembled, and whatever is left is tool free, no screwdriver or allen key required. Expect to attach the legs by hand and check that the back is locked into the frame before you sit down, then it is ready to use.

• Spot Clean, Light Dusting

  Care is spot clean: wipe a spill with a clean, barely damp cloth right away rather than letting it sit, skipping fabric upholstery cleaners made for woven covers since this is faux leather, not fabric. For everyday dust, a light brushing or vacuuming across the padded back and rolled arms is enough, no need for a deep clean unless something spills.

• Foam and Coils

  The seat height is 18.1 inches and the seat depth runs 21.3 inches, built on foam and cotton layered over coil and pocket springs rather than a single foam block, so it gives more support under weight without going flat. The chair is rated to hold 330 pounds, and the footrest extends as you lean back and sink into the recline.

• Leave 65 Inches When Reclined

  Upright the footprint is 34.6 inches wide by 36.6 inches deep, but reclined it needs 65 inches of depth, so measure the space behind it, not just in front, before it goes near a wall or a doorway. At 67.2 pounds and partially assembled, one person can carry it through a standard hallway without much trouble.

• Wood Frame, Coil Springs

  The frame is solid wood plus manufactured wood, built to carry the push back mechanism and a 330 pound rating. Inside, foam and cotton sit over coil and pocket springs, a sturdier setup than foam alone and part of why the seat holds its shape through the recline motion instead of sagging.

• Brown Faux Leather

  The upholstery is a faux leather in brown, with a mottled, weathered pattern that varies across every panel rather than a flat, single tone. Dark nailheads trace both rolled arms from the seat to the top, the main decorative detail against an otherwise plain, rounded shape.

• One Chair, Legs On

  One recliner arrives with the body upholstered and partially assembled, with any remaining legs or hardware attached by hand and no tools required. No ottoman, throw pillow, or cover comes with it, just the chair itself in the one color it ships in.

Good to know

• Tape a 34.6 by 36.6 inch rectangle; reclined it needs 65 inches of depth behind it.
• Seat height is 18.1 inches and seat width is 22.1 inches side to side.
• At 67.2 pounds it ships partially assembled with tool free assembly.
• Keep 330 pounds in mind; this is a manual push back, not a power recline.